How to Fix Hard Drive Corruption using CheckDisk CHKDSK

Over time hard drive could create errors for lots of reasons. Causes like power outrage, power surges, improper shutdowns & age of drive are some of the most common reasons for errors in hard drives.

The specialists at computer services offer a technique that can repair a damaged hard drive. It is kind of a check & at the end of it you can be sure if the hard drive is nearing its end. It is not a  difficult check. you can do it yourself. & if you have any kind of difficulty jogging it you can contact any time to our 24/7 computer support specialists. You require to narrate your computer system & they will advise you what you will require to do in the situation. If you're not a computer geek you can easily get the help of remote network support team on a nominal charge.

The tech support specialists desires the users to have a back up of the systems & all the important information before jogging the check because you can lose your invaluable information in the work of the jogging of the system depending on the extent of the damaged caused to the hard drive.

The specialists at computer services team require you the insert a Windows XP/2000 installation compact disc & restart the computer. you can get the prompt asking for the boot technique. you can get another prompt asking what you would like to do? Then you require to pick the letter "R" to enter the Windows Recovery Console.

You will get the prompt about what partition you would like to boot to & you will select the partition that has the Operating Systems installed in it. May be you will require to give an administrator password or may be you will require to enter basically by pressing enter button.

Another prompt will appear asking for command. You will require to type the command chkdsk /p & then you require the press enter on your keyboard.

But if one or more errors are found you can type the command chkdsk /r & press the enter button on your keyboard. Once you have pressed the enter button the CHKDSK will start checking for any errors in every sectors & will automatically repair them. The methods can take time depending on the size of the drive.

Now it is the time for checking the errors of your drive. The check will be run to check the errors. If you get any message like this "One or more errors detected on the volume", your hard drive errors then can be fixed by using CHKDSK. But if you don't get any of such messages then CHKDSK won't be able to fix the errors on your drive.  Then may be you will require to consult the computer services professional team.

Once the scanning for the testing job is done, & it returns to the command prompt you can type the command chkdsk /p & can press the button enter on your keyboard.

If you see no error in your drive you have successfully done your testing technique & your hard drive is repaired. If you see the errors again this means that the CHKDSK was unable t repair the damage.

Now you can exit the Recovery Console & can remove the compact disc of Windows XP/2000 installation.